Cause
Worn distributor shaft or bearings
Wear in the distributor's shaft or bushes letting it move where it should turn true. It applies to older engines with a mechanical distributor, and it matters because the distributor carries the ignition timing reference — so shaft movement is timing scatter.
The signature is a timing signal that wanders rather than fails. Play in the shaft lets the reluctor or pickup gap vary as the engine runs, so the module receives a signal whose edges move relative to the crankshaft — and it reports a reference or synchronisation fault while the pickup itself is healthy.
It gets worse with revs and load, since those are what deflect a worn shaft, so the complaint is a misfire or hesitation that appears under acceleration and clears at idle. Check the shaft for radial play by hand with the cap off — any perceptible side movement is too much. A worn drive gear produces the same scatter and is worth inspecting at the same time, since replacing the distributor without checking it repeats the fault.
Typically a moderate job.
Some of these codes mean you should stop driving
3 of the 3 codes this can cause indicate a fault where continuing to drive risks damage or is unsafe. Which one you have matters more than the cause does — read the code's own page before deciding.
Codes this can cause (3)
Codes where this is a likely explanation first, rather than merely a possible one.
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Others who found this
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about Worn distributor shaft or bearings.