Toyota 1MZ-FE (MZ family, 2.5 and 3.0)
3.0 L · V6 · naturally aspirated · petrol · 1994–2006
Also known as: 1mz, 3.0 v6, camry v6 engine, rx300 engine, es300 engine, 2mz-fe, 2mz
Toyota's 3.0 60° V6, in almost everything the company sold with six cylinders for a decade — Camry, Avalon, Sienna, Highlander, and the Lexus ES 300 and RX 300. 194 to 210 hp, the higher figure once VVT-i arrived in 1998.
It is the engine of the Toyota sludge affair, and that history is the first thing to establish about any example. Oil gelled in the engine rather than draining, and Toyota received 3,400 complaints by 2002, extended the warranty to eight years and unlimited miles, and settled a class action covering some 3.5 million Toyota and Lexus vehicles. The cars at risk are the 1997 to 2002 ones, and the settlement is long closed — so on a car bought today the question is not whether it is covered but whether it was ever cleaned.
What the sludge does is block the PCV system, and from there the symptoms read like several different faults: blue smoke, fouled plugs, and low compression concentrated in the rear bank, which is the harder one to reach and the one that runs hotter. Low compression on bank 2 alone, on this engine, is a sludge finding until proven otherwise rather than a worn-out engine.
On the VVT-i cars the actuator itself leaks or fails, which shakes at idle and takes power with it. Oil changes on time, with the right oil, are the whole of the prevention — which is an unsatisfying answer and the true one.
Cars fitted with this engine
14 generations, across 2 makes. From the authored catalogue — an absent car means the catalogue has not reached it, not that the engine was never fitted.
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Posted about this engine
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about 1MZ-FE (MZ family, 2.5 and 3.0).