Skip to content

Power Steering Pressure Sensor

Tells the engine module that the steering is loaded, so it can raise idle to absorb the load — hydraulic steering at full lock takes enough power to stall an engine at idle. The consequence of losing the signal is therefore not a steering complaint at all but an idle that dips or stalls when parking, which is why the code and the symptom seem unrelated.

Also known as: psp sensor, power steering switch, steering pressure switch, psp switch

Referenced by 11 codes

WhatsApp Telegram X Email

Codes involving this component (11)

Other components in Engine Management and Sensors

Information, not instruction

CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.

Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.

Working on this component

Be the first to write this up

Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.

What makes one worth reading:

  • The car — make, model, year and engine. The same fault behaves differently on each.
  • What you measured, not only what you replaced.
  • What actually fixed it — or that nothing did, which is worth knowing too.

Sign in or create an account to add what you found about Power Steering Pressure Sensor.