Skip to content

P0984 High Generic / SAE

P0984: Shift Solenoid E Control Circuit Range/Performance

WhatsApp Telegram X Email

What to do

If a solenoid is replaced and the gearbox still shifts badly afterwards, ask whether the adaptive values were reset and the relearn drive completed. On these transmissions that step is part of the job, and shifts can stay poor without it even when the repair was correct.

What this code means

The control circuit for shift solenoid E is responding outside its expected window. The point from P0770 belongs here more than anywhere: on transmissions of this complexity, replacing a solenoid is not the end of the repair. The module's learned shift adaptations are matched to the old part, and applying them to a new one produces harsh or flaring changes that then get blamed on the replacement. The reset takes minutes and a short relearn drive.

Likely causes

Start here

Less common

Symptoms

Components involved

Information, not instruction

CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.

Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.

Community experience

Be the first to write this up

Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.

What makes one worth reading:

  • The car — make, model, year and engine. The same fault behaves differently on each.
  • What you measured, not only what you replaced.
  • What actually fixed it — or that nothing did, which is worth knowing too.

Sign in or create an account to add what you found about P0984.