P27EE: Transmission Range Control A Position Sensor/Switch Circuit High
What to do
Apply the parking brake every time you park, and allow for the display being wrong. The module can no longer fully confirm which range the gearbox is in, so treat the selector display with suspicion until it is repaired — check the car is truly holding before you step away. If it refuses to leave park or to crank, that is the same caution, not a second fault.
What this code means
Transmission range control position sensor A is reading high.
A circuit reading high usually means a short to voltage or an open circuit leaving the line pulled up — the command level never changes at the pump, however hard the module drives it.
The position sensor is how the module knows the shift it commanded actually happened. Shift-by-wire has no cable and therefore no mechanical certainty: the selector asks, an actuator moves the range mechanism, and this sensor reports where the mechanism truly ended up. Command and confirmation are separate circuits on purpose, and this family is the confirmation side.
Losing confirmation is why the display misbehaves. A selector showing the wrong gear, a flashing P, refusal to leave park, or an engine that will not crank in park with everything mechanically fine — all of it is the module declining to guess where the gearbox is. It would rather refuse than act on a range it cannot verify, and with park involved, that caution is correct.
Two sensors share the job, and the letter names which one. Designs carry A and B for redundancy: with one lost, the module may carry on watchfully; with the two disagreeing, it protects. The sensors themselves fail the way all position sensors do — wear on the track, water in the connector, a harness chafed where it flexes.
Likely causes
Start here
- Faulty transmission range sensor · specialist
- Corroded or loose connector · specialist
- Damaged wiring harness · specialist
Rare
- Faulty transmission control module · specialist
Symptoms
Components involved
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Community experience
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about P27EE.