P2780: Schakelaar voor terugschakelen — circuit laag
Wat te doen
The car drives normally in D — what has failed is the manual shift request, not the gearbox. Leave the selector in drive and let it shift for itself until the circuit is repaired. Plan for long descents, because the usual answer — holding a low gear for engine braking — may not be available: slow down earlier and brake in shorter, firmer applications rather than dragging the brakes.
Wat deze code betekent
The downshift switch circuit is reading low.
A constant low usually means the line is shorted to ground — the module sees the switch held permanently in one state, so it stops trusting anything the circuit says.
This is the request side of a manual shift, not the gearbox itself. On a car with a manual gate or steering-wheel paddles, pulling for a gear closes a switch, and the transmission control module reads that request and decides whether to honour it. This circuit is that switch's wiring.
The car still drives, because D never asks. Fully automatic shifting does not use the shift request circuits at all — the module schedules gears from speed and load on its own. What stops working is the manual override: the gearbox ignores the paddle or the gate, or drops back to automatic shortly after a request.
On a paddle car, the wiring runs through the steering wheel's clock spring — the wound ribbon cable that lets the wheel turn while staying connected. A clock spring worn out by years of steering, or disturbed by steering-wheel or airbag work, takes the paddles with it. If this code arrived soon after any work behind the wheel, start there — and take it seriously beyond the convenience, because the same ribbon usually carries the horn and airbag circuits.
The selector gate has its own failure mode: the switch contacts wear and corrode. A gate that only registers some pulls, or registers one pull twice, is a tired switch rather than a transmission fault — and a far cheaper repair than anything inside the gearbox.
Do not let this code send anyone into the transmission. Nothing here touches the hydraulics: the fluid, clutches and solenoids are all innocent until the request signal has been proven at the module connector.
Waarschijnlijke oorzaken
Begin hier
- Gecorrodeerde of losse stekker · specialistisch
- Keuzeschakelaar van de versnellingsbak defect · specialistisch
- Kabelboom beschadigd · specialistisch
Minder vaak
- Wikkelveer in het stuurwiel defect · specialistisch
Zeldzaam
- Transmissieregelmodule defect · specialistisch
Symptomen
Betrokken onderdelen
Informatie, geen instructie
CarGeek is een naslagwerk, geen werkplaatshandboek. De pagina's zijn geschreven op basis van openbare bronnen en van wat anderen hebben ondervonden, nooit op basis van de servicedocumentatie van de fabrikant zelf, dus ze kunnen onjuist of onvolledig zijn voor jouw specifieke voertuig. Een deel van wat erin staat brengt echt gevaar met zich mee: hoogspanning, brandstof onder druk, opgeslagen energie en hete of bewegende delen.
Laat alles waarnaar je wilt handelen eerst controleren door iemand met een technische opleiding, aan de hand van de eigen procedure van de fabrikant voor jouw voertuig. Niets hier vervangt die procedure.
Ervaring uit de community
Wees de eerste die dit beschrijft
Hierover is nog niets geplaatst. Wat je ook hebt gevonden, het is het opschrijven waard — zelfs een doodlopend spoor bespaart iemand dezelfde middag.
Wat het de moeite waard maakt:
- De auto — merk, model, bouwjaar en motor. Dezelfde storing gedraagt zich per auto anders.
- Wat je gemeten hebt, niet alleen wat je vervangen hebt.
- Wat het echt verholpen heeft — of dat niets dat deed, wat ook nuttig is om te weten.
Inloggen of een account aanmaken om toe te voegen wat je hebt gevonden over P2780.