Also known as: s5-42, s5-47, s5-420, s5-470, zf s5-42, zf s5-47, zf s5-420, zf s5-470, zf5 5-speed
ZF's five-speed overdrive manual for Ford's heavy pickups — the gearbox the trade calls the ZF5. It arrived for 1987 in the F-350 cab and chassis and ran until 1997, when ZF's own six-speed S6-650 took over.
The two designations are the same gearbox at two torque ratings, and the numbers are the rating. The S5-42 is good for 420 lb-ft; the S5-47 is good for 470 lb-ft. That is where the alternative spellings S5-420 and S5-470 come from, and they name nothing different. The S5-42 ran from 1987 to 1994; the turbocharged Power Stroke outgrew its rating, and the slightly stronger S5-47 replaced it in diesel trucks from part way through 1994, standard for 1995 and retired after 1997.
The gear sets are not interchangeable between the two even though the gearboxes are. The S5-42 is the closer-ratio pair — 4.14, 2.37, 1.42, 1.00, 0.77 — where the S5-47 starts far lower at 5.08 and runs 2.60, 1.53, 1.00, 0.77. So a swapped truck will feel completely different in first and identical on the motorway, which is worth knowing before concluding that something is wrong.
The two will physically interchange without modification — but a petrol bellhousing pattern is not a diesel one, and that is the bolt-up that catches people out.
Almost everything reported as a gearbox fault on these is the hydraulic clutch. Grinding changes and rough engagement come from the release system far more often than from anything inside the case: a flexing firewall, worn pedal bushings, a worn master cylinder pushrod bushing, or air in the line. Bleed and inspect the clutch hydraulics before the gearbox is opened. Worn synchronisers do occur, reverse first.
A rollover rattle at idle in neutral is normal on a truck without a dual-mass flywheel. It is gear rattle, not a bearing.
It is an aluminium case and takes a little over three litres of Motorcraft MERCON V ATF — automatic transmission fluid in a manual gearbox, which surprises people. Gear oil in one of these is a mistake, not an upgrade.
Cars fitted with this gearbox
2 generations. Only where a source names the model and the generation together — a gearbox is documented as a product far more often than as a fitment, so this list is deliberately shorter than the truth.
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Community experience
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about ZF S5-42 / S5-47.