خرابی شیر یا شیلنگ PCV

The crankcase ventilation valve and the hoses around it, which draw blow-by gases out of the crankcase and feed them back into the intake to be burnt. It appears on lean codes and on idle control codes for the same underlying reason: every part of this circuit sits downstream of the airflow sensor, so anything that opens it admits air the engine never measured.

A split hose is the commonest version and the easiest to miss. The rubber hardens with heat and age and cracks on the underside where nobody looks, or splits only when it flexes at certain engine loads — which produces a lean condition that comes and goes and reads like a failing sensor. A valve stuck open does the same thing continuously; stuck closed it does the opposite, pressurising the crankcase until oil is forced past seals that were perfectly good.

The distinction worth holding is between the valve and the plumbing. The valve is a cheap part and gets replaced first, but a new valve into a perished hose changes nothing. Smoke-test the whole circuit rather than replacing the valve on suspicion — it finds the split in minutes and it also finds the intake leaks elsewhere that present identically.