P0C5F: Drive Motor B Position Sensor Circuit B
What to do
As P0C50 — the two channels are one measurement, so losing either loses the angle. Check wiring and shielding before the sensor.
What this code means
Channel B of the position sensor on drive motor b has a circuit fault.
The two points that make this family readable — that it is not the whole-sensor code at P0A3F, and that channels A and B are the sine and cosine halves of one measurement rather than two independent sensors — are at P0C50.
Likely causes
Start here
- Faulty motor position sensor · specialist
- Corroded or loose connector · easy
Less common
- Chafed harness between transaxle and inverter · specialist
- Failed sensor reference voltage supply · moderate
- Motor position sensor incorrectly fitted or misaligned · specialist
Symptoms
Components involved
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Community experience
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about P0C5F.