Skip to content

P0793 High Generic / SAE

P0793: Intermediate Shaft Speed Sensor A Circuit No Signal

WhatsApp Telegram X Email

What to do

Expect a fixed gear or restricted shifting. Ask what the sensor tip looked like when it came out — metal on it changes the diagnosis from a sensor fault to a symptom of wear elsewhere.

What this code means

No intermediate shaft speed signal where one is expected. An open circuit, a failed sensor, or a reluctor ring that has lost teeth.

As with the other transmission speed sensors, metallic debris on the tip deserves particular attention. These sensors are magnetic and sit in circulating fluid, so a transmission wearing internally coats them in fine metal. A blinded sensor is reporting the consequence of a larger problem, and finding its tip furred is a reason to examine the fluid and the pan rather than to fit a replacement and consider the job finished.

Likely causes

Start here

Less common

Symptoms

Components involved

Information, not instruction

CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.

Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.

Community experience

Be the first to write this up

Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.

What makes one worth reading:

  • The car — make, model, year and engine. The same fault behaves differently on each.
  • What you measured, not only what you replaced.
  • What actually fixed it — or that nothing did, which is worth knowing too.

Sign in or create an account to add what you found about P0793.