P058C: Monitoramento de temperatura do módulo de monitoramento da bateria — desempenho
O que fazer
If this car has been through several batteries in a few years, mention it. This sensor decides how the battery is charged, and a wrong reading quietly ruins batteries over months — so the answer may be this sensor rather than another new battery.
Say whether the battery has been changed recently, and whether the sensor clamp was refitted and tightened properly. It sits in the negative terminal clamp and a poor joint there affects everything it measures.
Ask for it to be checked from cold, ideally after the car has stood overnight, since that is when every temperature sensor should agree.
Expect stop-start to be disabled, which is the system being cautious rather than a second fault.
O que este código significa
The battery monitoring sensor's temperature measurement is not behaving credibly.
Temperature is not a side feature of a battery monitor — it is central to the calculation it exists to make. A battery's capacity, its internal resistance and the voltage it should be charged to all change substantially with temperature. A cold battery accepts charge poorly and needs a higher charging voltage; a hot one needs less, or it gasses and ages.
So the state-of-charge figure the module reports is temperature-corrected, and a wrong temperature makes that figure wrong without anything looking broken.
The consequences are slow and expensive rather than sudden. Undercharging sulphates a battery over months; overcharging cooks it. Either way the failure arrives later, looks like an ordinary flat battery, and gets a new battery fitted — which then does the same thing.
A car on its third battery in a few years is worth checking here rather than buying a fourth.
Range/performance is caught by comparison, and the cold soak is decisive: after standing overnight, this sensor should read close to ambient and close to every other temperature sensor on the vehicle.
Check the clamp connection before the sensor. The monitor sits in the battery's negative terminal clamp, so a poor joint there — corrosion, or a clamp not tightened after a battery change — affects everything it measures.
Causas prováveis
Comece aqui
- Sensor de monitoramento da bateria com defeito · moderado
- Conector corroído ou frouxo · fácil
Menos comum
- Bateria nova não registrada no veículo · especializado
- Resistência alta na fiação do sensor · moderado
- Sensor com desvio fora da calibração · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P058C.