U0125: Модуль многоосевого датчика ускорения A — потеряна связь
Что делать
Expect a stability control warning; the car will otherwise drive normally, with the same reduced protection described at U0122.
If several sensor codes are stored together, that is usually one part. Modern vehicles put yaw rate and the acceleration sensors in a single small module, so codes naming them separately typically point at one connector.
One thing to insist on if the module is replaced: that it is calibrated afterwards. These sensors only mean anything if the car knows which way round they are fitted, and an uncalibrated one reports believable numbers about the wrong axis — which is worse than no sensor, because the system acts on them.
Mention any water in the footwells or a leaking screen or sunroof seal; the module usually sits low in the middle of the car and that is a common cause.
Что означает этот код
The multi-axis acceleration sensor module has stopped being heard from. The general reasoning is at U0100.
This code exists because the separate sensors described at U0123 and U0124 were combined into one package, and it is the arrangement most vehicles now use. A single module measures yaw, lateral acceleration and longitudinal acceleration — and on vehicles with roll-over protection, roll rate as well — because the sensing elements are small, cheap and best kept together at a known point on the vehicle.
Two consequences follow from that packaging, and both save time.
- One fault produces several codes. A vehicle storing this alongside U0123 and U0124 is describing one module, not three, and the presence of all of them is a strong argument for the connector rather than for the sensors.
- Orientation matters. A combined sensor only means anything if the vehicle knows which way it is fitted, so these modules must be installed the correct way round and calibrated after replacement. A module that is fitted but not calibrated reports plausible values in the wrong axes, and stability control will act on them.
Mounted low and centrally, so the water ingress point at U0123 applies here too.
Вероятные причины
Начните отсюда
- Разъём окислен или неплотно посажен · простой ремонт
- Проникновение воды в разъём · ремонт средней сложности
- Проводка шины данных повреждена · ремонт средней сложности
Встречается реже
- Датчик не откалиброван после замены · ремонт для специалиста
- Неисправный датчик скорости рыскания · ремонт средней сложности
Симптомы
Задействованные компоненты
Информация, а не инструкция
CarGeek — это справочник, а не руководство по ремонту. Его страницы составлены по открытым источникам и по опыту других людей, но не по сервисной документации производителя, поэтому для вашего конкретного автомобиля они могут быть неверными или неполными. Часть описанного связана с реальной опасностью: высокое напряжение, топливо под давлением, накопленная энергия, горячие и движущиеся детали.
Всё, по чему вы собираетесь действовать, сначала проверьте с человеком, имеющим техническую подготовку, по собственной процедуре производителя для вашего автомобиля. Ничто здесь не заменяет эту процедуру.
Опыт сообщества
Напишите об этом первым
Об этом пока ничего не опубликовано. Всё, что вы выяснили, стоит записать — даже тупиковый путь сэкономит кому-то те же полдня.
Что делает такой отчёт полезным:
- Автомобиль — марка, модель, год и двигатель. Одна и та же неисправность ведёт себя на каждом по-своему.
- Что вы измерили, а не только что заменили.
- Что действительно помогло — или что не помогло ничто, это тоже стоит знать.
Войти или создать учётную запись для добавления того, что вы выяснили по теме U0125.