U0410: Invalid Data Received From Fuel Pump Control Module A
What to do
The engine will probably run, but do not set off on a long journey until the fuel pressure has actually been measured — a fuel delivery fault can leave you stranded with little warning.
Ask for the fuel pressure to be measured with a gauge rather than read from the scan tool. That one measurement separates two very different problems: a sensor reporting wrongly on a healthy fuel system, or a genuine fuel supply problem that the sensor is honestly reporting. They lead to completely different repairs.
Mention any of these, because they point at a genuinely tiring pump: hesitation under load, difficulty starting when the engine is hot, or a whining noise from the fuel tank area. This module measures how hard the pump is working, and a pump drawing more current than it should is one that is wearing out — which makes this code an unusually early warning, worth acting on rather than clearing.
A blocked fuel filter is also worth ruling out, since it is cheap and produces the same low-pressure picture.
What this code means
The fuel pump control module is broadcasting data that cannot be accepted as true. See U0400 for the family's framing.
A fuel pump stopped being a simple on-or-off device when manufacturers began varying its speed, and that is why it has a module. Running the pump only as hard as the engine needs reduces electrical load, keeps the fuel cooler, and extends the pump's life — so the module drives it at a commanded rate and reports back the pressure achieved and the current drawn.
Those two reported values are the substance of this code, and each has a distinct meaning worth separating.
A pressure report that cannot be true may be a failing pressure sensor, or it may be an honest report of a genuine fuel delivery problem — the U0400 point about data sometimes being accurate. A blocked filter, a failing pump or a restricted line produces real pressure the module correctly reports and the engine module correctly rejects as insufficient.
A current report that cannot be true is the more informative one. A pump drawing far more current than commanded is a pump wearing out — increasing friction as bearings and vanes wear — and this is one of the few places where a module's own report gives early warning of a mechanical failure. A vehicle that has been hot-starting poorly or hesitating under load, with this code stored, is very likely reporting a genuinely tiring pump.
So the practical advice is to have the actual fuel pressure measured rather than inferred, because that single measurement distinguishes a sensor problem from a fuel supply problem, and they lead to completely different repairs.
One caution worth stating: a fuel pump that is being under-driven or over-driven because of this fault can leave a driver stranded without much warning. The corpus marks this as drivable because the engine runs, but a long journey is not a good idea until the pressure has been checked.
Likely causes
Start here
- Restricted fuel filter · easy
- Low fuel supply pressure · moderate
- Corroded or loose connector · easy
Less common
- Faulty fuel pump control module · specialist
- Damaged wiring harness · moderate
- Faulty receiving module input · specialist
Symptoms
Components involved
Information, not instruction
CarGeek is a reference, not a service manual. Its pages are written from public sources and from what other people have found, never from a manufacturer's own service information, so they can be wrong or incomplete for your particular vehicle. Some of what they describe carries real risk: high voltage, fuel under pressure, stored energy, hot and moving parts.
Have anything you intend to act on checked by a trained person against the manufacturer's own procedure for your vehicle. Nothing here replaces that procedure.
Community experience
Be the first to write this up
Nothing posted about this yet. Whatever you found is worth writing down — even a dead end saves someone the same afternoon.
What makes one worth reading:
- The car — make, model, year and engine. The same fault behaves differently on each.
- What you measured, not only what you replaced.
- What actually fixed it — or that nothing did, which is worth knowing too.
Sign in or create an account to add what you found about U0410.