P340D: Soupape de désactivation ou d'échappement — circuit de commande, banc 2

The exhaust valve deactivation control circuit for bank 2 has an electrical fault.

This is the bank-level code, and it says something different from the per-cylinder ones.

A fault reported for a whole bank points at what the cylinders on that bank share — the oil gallery feeding them, the manifold the solenoids sit in, a common supply or ground, or the module output driving the group. A single cylinder's code points at that cylinder's solenoid and its wiring.

So the two are diagnosed from opposite ends, and the most useful thing to do first is read every stored code rather than the one that came up. Several cylinders on one bank is really a bank fault, and chasing them individually is how three good solenoids get replaced.

Cylinder deactivation shuts down half the engine while you are driving, and the driver is not meant to notice.

Under light load — a level motorway cruise asks a large engine for a small fraction of what it can make — an engine wastes fuel pumping air it does not need. The throttle is nearly closed, so every intake stroke drags against a vacuum. That pumping loss is a real fraction of the fuel burned.

So the engine switches cylinders off: fuel and spark stop, and the valves are held shut. The remaining cylinders must then work harder to make the same power, which opens the throttle further and reduces the pumping loss for all of them. That is the whole gain — it comes from unthrottling the cylinders still running, not from the ones that stopped.

Both valves have to stay shut, and that is the part worth understanding.

If only the fuel were cut, the cylinder would keep pumping air — dragging on the crankshaft, and pushing cold oxygen through the catalyst, which upsets the mixture the oxygen sensors are trying to read. So the valves are held closed and the charge is trapped.

A cylinder full of trapped air becomes a spring. The piston compresses it on the way up and it pushes back on the way down, returning most of the energy. A deactivated cylinder is nearly free to carry — and that only works if the trap holds, which is why the intake and exhaust circuits are monitored separately and each gets its own code.

Almost all of these systems are actuated by engine oil, and that is why oil condition dominates the causes.

The solenoid does not move the valve. It routes oil pressure to a lifter that collapses, so the camshaft lobe pushes into a part that gives way instead of opening the valve. The oil is the working fluid, the signal path and the lubricant at once.

Which makes this system unusually sensitive to oil that a normal engine would tolerate. Oil that is old, overdue, of the wrong viscosity, or diluted with fuel is slower to move and more likely to leave varnish in passages narrower than a pencil lead. Low oil level does it too, because the pressure that holds a lifter in position falls away first at idle when it is hot.

So before condemning a solenoid: check the oil level, the oil condition and when it was last changed. On these engines that is diagnosis, not a preliminary.

A numbering note specific to this block. The per-cylinder codes run through numbers that read as decimal — P3401 to P3496, twelve cylinders of eight codes each — and the standard kept the hex-only slots for the bank-level faults, which is why this code sits at a letter-tailed number while its per-cylinder siblings do not. The gap between P3409 and P3410 is not a gap; P340A to P340D are these codes.