P2679: Entgasungsventil des Kühlkreislaufs — Steuerstromkreis niedrig
Was zu tun ist
Probably nothing to feel immediately, but worth sorting rather than leaving — this valve vents air out of the cooling system, and trapped air causes hot spots the temperature gauge cannot see.
Ask for the connector itself to be inspected for coolant contamination before the valve is replaced. This part sits in the hottest, wettest part of the cooling system, and a slightly weeping hose joint or seal above it will drip coolant into the plug. Coolant conducts electricity and corrodes terminals, so it produces a genuine electrical fault with nothing wrong with the wiring — and a new valve plugged into a contaminated connector fails the same way. Crusty green or white deposits in the plug are the giveaway.
Was dieser Code bedeutet
The coolant degassing valve's control circuit reads below its valid range — a short to ground, or a module output that has failed low.
What the valve does and why trapped air matters is set out at P2678.
One cause deserves naming first here, because it is specific to where the part lives and it is not really an electrical fault at all. This valve sits at a high point of the cooling system, in the flow of hot coolant, and its connector sits directly above or beside a joint carrying that coolant under pressure. A weeping hose clip, a seeping seal or a slightly porous plastic housing puts coolant onto that plug, and coolant is conductive and corrosive — it bridges the terminals and then eats them.
The corpus records this pattern elsewhere as coolant leaking into a sensor connector, and it behaves the same way here: the electrical fault is real, the wiring is undamaged, and replacing the valve without finding the seep means the new one's connector corrodes too. Green or white crust in the plug is the tell.
Driveability is normally unaffected in the short term; the consequence is air accumulating over time.
Wahrscheinliche Ursachen
Hier anfangen
- Kühlmittel im Sensorstecker · mittel
- Leitung mit Masse kurzgeschlossen · mittel
- Korrodierter oder loser Stecker · einfach
- Entlüftungsventil des Kühlsystems defekt · mittel
Seltener
- Endstufe des Steuergeräts defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2679.