P2795: Schaltrichtung — Stromkreis hoch
Was zu tun ist
Expect refused or harsh gears rather than none at all, and be ready for limp mode. If the box drops to a single gear it is protecting itself, not failing further. Driving on briefly is usually safe, but a mechanism stranded between gears can leave you without drive without warning — treat the first refusal as the moment to book it in, not the tenth.
Was dieser Code bedeutet
The gear shift direction circuit is reading high.
A constant high usually means a short to voltage or a broken wire leaving the line pulled up — either way the signal never changes, and a switch that cannot change state is no switch at all.
This family is the shift axis — engaging a gear within the chosen gate — and its partner family two codes back drives the select axis.
An automated manual shifts with motors instead of your hand, and this circuit drives one of the two motions. Moving a gear lever is really two movements: select side to side to choose a gate, then shift fore and aft to engage a gear. An automated gearbox performs exactly the same mechanics with a gate select actuator for one axis and a gear shift actuator for the other, both commanded by the transmission control module.
A direction circuit fault can strand the mechanism mid-move, which is why this family bites harder than a request-switch fault. The box may end up between gears, refuse a particular gear while managing others, or stay in whatever it last engaged and limp. The pattern of which gears still work traces which axis is in trouble.
The actuator is the likeliest culprit, its wiring the cheapest. These motors live on the outside of the gearbox in engine-bay heat and road spray; their connectors corrode, their windings tire, their linkages stiffen. Prove the circuit at the connector before condemning the actuator, and prove the actuator before anyone opens the gearbox — the internals are innocent in almost every case.
Wahrscheinliche Ursachen
Hier anfangen
- Schaltsteller defekt · Fachwerkstatt
- Getriebestecker korrodiert · Fachwerkstatt
- Kabelbaum des Getriebes beschädigt · Fachwerkstatt
Seltener
- Leitungsbruch in der Stellerleitung · Fachwerkstatt
Selten
- Getriebesteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2795.