P24C2: Système de mesure de la température des gaz d'échappement — corrélation de plusieurs capteurs, banc 1
Que faire
Mention any exhaust work the car has had, however minor. This code says the temperature sensors along the exhaust disagree with each other, and a sensor refitted in a slightly different position after a repair is a common and entirely mechanical cause.
Expect diagnosis to take a little time. The code names the disagreement rather than which sensor is wrong, so the garage has to compare readings from all of them — usually starting from cold, which may mean leaving the car overnight.
The car will generally drive normally, though it may attempt particulate filter regenerations more often than it should, which shows up as worse fuel consumption.
Ce que signifie ce code
The exhaust gas temperature sensors on bank 1 disagree with one another by more than they should.
A correlation code names a relationship rather than a component, and that is what makes it distinctive. No single sensor is out of range. They are individually plausible and collectively impossible — and the module knows the exhaust well enough to say so.
The test is usually done when the exhaust should be uniform, typically after a long soak with the engine off. At that point every sensor in the pipe should read close to ambient and close to each other. One that reads twenty degrees warmer than its neighbours after standing overnight has drifted, and the module needs no running data to prove it.
The awkward part is that the code names the system, not the culprit. Identifying which sensor drifted needs live data from all of them, compared at a known condition.
Do not assume the sensor is faulty just because it is the odd one out. A sensor reading differently because it sits in a different place — moved during an exhaust repair, or in a pocket rather than the gas stream — is mechanically misplaced rather than electrically failed.
Wiring resistance produces the same picture. A corroded terminal on one sensor shifts its reading consistently, which looks exactly like drift until the connector is inspected.
Causes probables
Commencez ici
- Capteur ayant dérivé hors calibrage · modérée
- Résistance élevée dans le câblage du capteur · modérée
Moins fréquent
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P24C2.