P24C2: Messsystem für die Abgastemperatur — Korrelation mehrerer Sensoren, Bank 1
Was zu tun ist
Mention any exhaust work the car has had, however minor. This code says the temperature sensors along the exhaust disagree with each other, and a sensor refitted in a slightly different position after a repair is a common and entirely mechanical cause.
Expect diagnosis to take a little time. The code names the disagreement rather than which sensor is wrong, so the garage has to compare readings from all of them — usually starting from cold, which may mean leaving the car overnight.
The car will generally drive normally, though it may attempt particulate filter regenerations more often than it should, which shows up as worse fuel consumption.
Was dieser Code bedeutet
The exhaust gas temperature sensors on bank 1 disagree with one another by more than they should.
A correlation code names a relationship rather than a component, and that is what makes it distinctive. No single sensor is out of range. They are individually plausible and collectively impossible — and the module knows the exhaust well enough to say so.
The test is usually done when the exhaust should be uniform, typically after a long soak with the engine off. At that point every sensor in the pipe should read close to ambient and close to each other. One that reads twenty degrees warmer than its neighbours after standing overnight has drifted, and the module needs no running data to prove it.
The awkward part is that the code names the system, not the culprit. Identifying which sensor drifted needs live data from all of them, compared at a known condition.
Do not assume the sensor is faulty just because it is the odd one out. A sensor reading differently because it sits in a different place — moved during an exhaust repair, or in a pocket rather than the gas stream — is mechanically misplaced rather than electrically failed.
Wiring resistance produces the same picture. A corroded terminal on one sensor shifts its reading consistently, which looks exactly like drift until the connector is inspected.
Wahrscheinliche Ursachen
Hier anfangen
- Sensor aus der Kalibrierung gedriftet · mittel
- Hoher Widerstand in der Sensorleitung · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24C2.