P2588: Positiesensor B van de laaddrukregeling — circuit laag
Wat te doen
The engine will feel flat and may go into reduced power. It is not usually damaging, so getting it to a workshop is fine.
Ask for the wiring to be inspected before the sensor is replaced. This loom lives beside a turbocharger housing that runs red hot, and on a twin-turbo engine there are two of them in a crowded bay — heat-damaged insulation is one of the commonest findings, and a new sensor on a damaged loom fails the same way.
Worth mentioning: if the other turbocharger's position sensor has also set a code, say so. Two at once usually means a shared power or earth wire rather than two failed sensors, which is a much smaller repair.
Wat deze code betekent
The second turbocharger's vane position circuit reads below its valid range — a short to ground, a failed reference supply, or a sensor that has dropped to the bottom of its scale.
The module loses closed-loop control of that turbocharger and defaults its vanes to a safe position, so boost falls away.
Heat is the reason this circuit fails more often than most, and on a twin-turbo installation there is more of it. Two turbine housings running red hot in one engine bay leave less room and less air between hot metal and the looms routed past it, so insulation hardens faster and chafes sooner than the same part would on a single-turbo engine. Wiring damage is a leading cause here rather than an afterthought.
One check is worth doing before the sensor is condemned: read the A-side codes as well. A shared reference supply or a common ground feeding both sensors will take both down, and two position codes at once point at the supply rather than at either sensor. That is a cheap thing to establish and it prevents two sensors being replaced to fix one wire.
Waarschijnlijke oorzaken
Begin hier
- Bedrading kortgesloten met massa · gemiddeld
- Hitteschade aan sensor of bedrading · gemiddeld
- Positiesensor van de turboschoepen defect · gemiddeld
Minder vaak
- Gecorrodeerde of losse stekker · eenvoudig
- Referentiespanningsvoeding van de sensor uitgevallen · gemiddeld
Symptomen
Betrokken onderdelen
Informatie, geen instructie
CarGeek is een naslagwerk, geen werkplaatshandboek. De pagina's zijn geschreven op basis van openbare bronnen en van wat anderen hebben ondervonden, nooit op basis van de servicedocumentatie van de fabrikant zelf, dus ze kunnen onjuist of onvolledig zijn voor jouw specifieke voertuig. Een deel van wat erin staat brengt echt gevaar met zich mee: hoogspanning, brandstof onder druk, opgeslagen energie en hete of bewegende delen.
Laat alles waarnaar je wilt handelen eerst controleren door iemand met een technische opleiding, aan de hand van de eigen procedure van de fabrikant voor jouw voertuig. Niets hier vervangt die procedure.
Ervaring uit de community
Wees de eerste die dit beschrijft
Hierover is nog niets geplaatst. Wat je ook hebt gevonden, het is het opschrijven waard — zelfs een doodlopend spoor bespaart iemand dezelfde middag.
Wat het de moeite waard maakt:
- De auto — merk, model, bouwjaar en motor. Dezelfde storing gedraagt zich per auto anders.
- Wat je gemeten hebt, niet alleen wat je vervangen hebt.
- Wat het echt verholpen heeft — of dat niets dat deed, wat ook nuttig is om te weten.
Inloggen of een account aanmaken om toe te voegen wat je hebt gevonden over P2588.