P2588: Positionssensor B der Ladedruckregelung — Stromkreis niedrig
Was zu tun ist
The engine will feel flat and may go into reduced power. It is not usually damaging, so getting it to a workshop is fine.
Ask for the wiring to be inspected before the sensor is replaced. This loom lives beside a turbocharger housing that runs red hot, and on a twin-turbo engine there are two of them in a crowded bay — heat-damaged insulation is one of the commonest findings, and a new sensor on a damaged loom fails the same way.
Worth mentioning: if the other turbocharger's position sensor has also set a code, say so. Two at once usually means a shared power or earth wire rather than two failed sensors, which is a much smaller repair.
Was dieser Code bedeutet
The second turbocharger's vane position circuit reads below its valid range — a short to ground, a failed reference supply, or a sensor that has dropped to the bottom of its scale.
The module loses closed-loop control of that turbocharger and defaults its vanes to a safe position, so boost falls away.
Heat is the reason this circuit fails more often than most, and on a twin-turbo installation there is more of it. Two turbine housings running red hot in one engine bay leave less room and less air between hot metal and the looms routed past it, so insulation hardens faster and chafes sooner than the same part would on a single-turbo engine. Wiring damage is a leading cause here rather than an afterthought.
One check is worth doing before the sensor is condemned: read the A-side codes as well. A shared reference supply or a common ground feeding both sensors will take both down, and two position codes at once point at the supply rather than at either sensor. That is a cheap thing to establish and it prevents two sensors being replaced to fix one wire.
Wahrscheinliche Ursachen
Hier anfangen
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2588.