P215C: Correlação entre a velocidade do eixo de saída e a das rodas
O que fazer
Check whether all four tyres match — same size, same make, and similar tread depth. On a four-wheel-drive vehicle this genuinely matters: different rolling circumferences make the axles work against each other, which is what this fault detects and which damages the transfer case if it is left.
Mention a space-saver spare, or a single tyre replaced recently, since either can be enough to cause this.
Say whether the fault appears under acceleration or load rather than at steady speed. That pattern suggests something in the driveline slipping rather than a sensor, which is a different and more important finding.
Mention any vibration, binding on tight turns, or noise from underneath, which support a driveline cause.
O que este código significa
The transmission output shaft speed and the wheel speed sensors do not agree.
This is the more direct of the two correlation checks, comparing the gearbox output against the wheels themselves rather than against a derived vehicle speed. Between them there is only the final drive and the tyres, so the arithmetic is simple and a disagreement is meaningful.
Which makes the causes shorter and more physical than its sibling's.
- Mismatched tyres, front to rear or side to side. On a four-wheel-drive vehicle this matters more than most owners realise — different rolling circumferences make the axles fight each other, which this check notices and which also damages the transfer case over time.
- A wheel speed sensor or its tone ring, where a cracked reluctor gives an erratic count.
- The output speed sensor itself.
There is one mechanical cause worth naming because it is not a sensor at all. On a four-wheel-drive vehicle, a slipping clutch pack or viscous coupling lets the driven wheels turn at a different rate from the gearbox output — the sensors are all correct and the driveline is slipping. A check that keeps failing under load but passes on a steady cruise fits that.
Ask what tyres are fitted and whether they match, before anything is measured. A single replacement tyre of a different make or wear state is enough on some vehicles, and it is free to establish.
Causas prováveis
Comece aqui
- Pneus desiguais ou de medida inadequada · moderado
- Sensor de rotação da roda com defeito · moderado
- Roda fônica danificada · moderado
Menos comum
- Sensor de rotação de saída com defeito · moderado
- Pacote de embreagem da tração integral patinando · especializado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P215C.