P020C: Cylindre 3 — calage de l'injection
Que faire
Ask for all the injectors to be tested rather than just the one named, especially on a high-mileage engine. A leak-back test compares them against each other and shows whether one has failed or the whole set is wearing out — and that changes the repair decision considerably.
Mention any recent injector work and whether calibration codes were programmed in. An injector fitted without its code sets this fault with a perfectly good part.
Say whether the engine is rough from cold, warm, or both. Cold-only roughness points at glow plugs or compression rather than injection timing on that cylinder.
Ce que signifie ce code
Injection timing on cylinder 3 is not where the module commanded it to be.
On a four-cylinder engine this is the third in the firing order, and on a straight six it sits in the middle of the block — a position with its own characteristic problem. The centre cylinders of an inline engine run hottest, because they have cylinders either side of them rather than one side open to coolant flow. Injectors there age faster, and a timing deviation that appears on a middle cylinder first is often the beginning of a set rather than an isolated fault.
That is worth knowing before agreeing to replace one injector. Where the others are the same age and mileage, replacing a single injector on a high-mileage engine frequently buys a few months before the next one declares itself.
The diagnosis is otherwise the family's. The module derives combustion timing from the crankshaft's instantaneous speed, so a cylinder that burns late, burns weakly, or does not burn cleanly all disturb the same measurement. Compression, glow plug and injector each have to be eliminated on that cylinder before the injector is condemned by position alone.
A leak-back test across all injectors is the measurement that settles it, because it compares them against each other rather than against a specification — and a set that is drifting together is a different conversation from one that has failed.
Causes probables
Commencez ici
- Injecteurs de carburant usés ou fuyants · spécialisée
- Injecteur de carburant hors service · spécialisée
Moins fréquent
- Injecteur monté sans saisie de son code de calibrage · spécialisée
- Compression moteur faible · spécialisée
- Joint d'injecteur qui fuit · spécialisée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P020C.