P0EF8: Capteur de tension d'entrée B du chargeur de batterie A — circuit, plage/performance
Que faire
The car will drive. Charging may be much slower at three-phase charge points while remaining normal at home, which is the signature of this fault rather than of a tired battery or a bad charger. Note where it is slow and by how much.
Ce que signifie ce code
The circuit for one of the charger's input voltage sensors is faulty.
Three sensors watching the charger's alternating-current input is not redundancy — it is almost certainly three phases.
A domestic supply has one live conductor. A three-phase supply has three, and much of the world's public and commercial charging is three-phase, because it delivers three times the power through conductors of the same size. A charger able to use it must measure each phase separately.
Which gives these codes an unusually specific diagnostic value: they name a phase. A fault on sensor B alone points at one leg of the supply — one conductor of the cable, one pin in the inlet, one branch of the installation — and that is a far smaller thing to inspect than "the charging system".
It also explains a complaint that otherwise makes no sense: a car that charges at full speed from one three-phase point and at a third of the rate from another. A charger that cannot verify one phase will not use it, so it falls back to single-phase charging and the driver sees a rate that has inexplicably collapsed at some chargers and not others.
So the test is not "does it charge" but "how fast, and where". A clean fall to a third of the expected rate on a three-phase point is close to diagnostic.
Reads plausibly and disagrees with the other phases. On a three-phase supply the other two are the reference — they should be equal in magnitude, so one differing is caught immediately.
Causes probables
Commencez ici
- Chargeur embarqué défectueux · spécialisée
- Connecteur corrodé ou mal enclenché · spécialisée
Moins fréquent
- Prise de charge ou broches endommagées · modérée
- Circuit ouvert dans le câblage du capteur · spécialisée
- Faisceau de câblage endommagé · spécialisée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P0EF8.