U0308: Incompatibilité logicielle avec le calculateur de l'actionneur de papillon
Que faire
Expect reduced power — possibly quite severely limited — and understand that the throttle body is probably fine.
Your accelerator is not connected to the engine by a cable. The pedal and the throttle each carry two or three sensors, and the computers constantly cross-check them against each other, because a single sensor trusted on its own could open a throttle nobody asked to open.
This code means two computers are running software that applies those checks differently. When the car cannot resolve that cross-check, it does the safe thing and limits the throttle. Nothing is broken.
The important part: do not let the throttle body be cleaned or replaced on the strength of this. Reduced power plus a throttle code sends people straight there, and it is a real cost on a healthy part that does not fix the fault.
And one thing to expect afterwards, so you do not mistake it for a new problem. After the software is corrected, the throttle has to relearn its closed position. Until that is done the idle may be poor or the engine may not idle at all — that is a procedure, not a fault, and it takes a few minutes.
Ce que signifie ce code
A module is running software that does not belong with the throttle actuator control module's. See U0300 for the family and U0301 for why the named module is not the accused.
Electronic throttle control is the system on a vehicle with the most redundancy built into it, and that is exactly why a software mismatch shuts it down rather than tolerating it.
There is no cable. The pedal carries two or three independent position sensors, the throttle body carries two more, and the module continuously checks each against the others — because a single sensor believed on its own could open a throttle nobody asked to open. The tolerances for those comparisons, and the response when they fail, are defined in software.
So two modules at different calibration levels may apply different tolerances to the same signals, and the vehicle's correct answer to a redundancy check it cannot resolve is to give up authority over the throttle: a limited maximum opening, reduced power, or idle only. That is P2104's graded response, arriving for a configuration reason rather than a sensor one.
Which produces the misdiagnosis this page prevents. Reduced power with a throttle-related code sends people to the throttle body, and it gets cleaned or replaced — a real cost on a healthy part, and one that does not clear the fault.
One thing to expect after the software is corrected, so it is not mistaken for a new problem. A throttle body must relearn its closed position after the module is reprogrammed — the P2176 argument. Until that adaptation is done the idle may be poor or the engine may not hold idle at all, and it is a procedure rather than a fault.
Causes probables
Commencez ici
Moins fréquent
- Calculateur d'occasion verrouillé sur un autre véhicule · spécialisée
- Programmation du calculateur interrompue · spécialisée
- Calibrage logiciel obsolète · spécialisée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de U0308.