P2682: Válvula de desvio A do líquido de arrefecimento do motor — circuito de controle baixo
O que fazer
Expect slow warm-up, a cool-running engine and a weak heater. Not dangerous.
Ask for the connector and the thermostat housing to be checked for coolant leakage before the valve is replaced. This valve is mounted on or in the thermostat housing, surrounded by seals and hose joints, and on many engines that housing is plastic and goes porous with age. A slight weep drips coolant into the plug, and because coolant conducts and corrodes it causes a real electrical fault with nothing wrong with the wiring. If that is what has happened, the housing is the repair and the valve may be perfectly good.
As at P2681, do not let a thermostat be fitted on the assumption that slow warm-up must be one — on this engine the temperature is controlled electrically.
O que este código significa
The coolant bypass valve's control circuit reads below its valid range — a short to ground, or a module output that has failed low.
What the valve does, and why slow warm-up on these engines is not automatically a thermostat, is set out at P2681.
The coolant-in-the-connector mechanism described at P2679 applies here with particular force, because of where this valve is mounted. It is part of the thermostat housing or bolted directly to it — surrounded by hose joints, seals and, on many engines, a plastic housing that becomes porous with age. A housing that has begun to weep puts coolant straight onto its own connector, and the electrical fault that follows names the valve while the actual problem is a leaking housing that will need replacing anyway.
So the sequence to insist on is: look at the plug and the housing before the valve is condemned. If there is coolant in the connector, finding where it came from is the repair, and the valve may well be fine.
The driveability consequence is as at P2681 — a cool-running engine rather than an overheating one, in most designs.
Causas prováveis
Comece aqui
- Vazamento de líquido de arrefecimento no conector do sensor · moderado
- Fiação em curto com a massa · moderado
- Válvula de bypass do arrefecimento com defeito · moderado
- Conector corroído ou frouxo · fácil
Menos comum
- Falha no driver do módulo de controle · especializado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P2682.