Zum Inhalt springen

P050A Mittel Generisch / SAE

P050A: Leerlaufregelsystem beim Kaltstart — Funktion

WhatsApp Telegram X E-Mail

Was zu tun ist

Say whether the engine idles unevenly or dips for the first thirty seconds or so after a cold start, then settles. That is exactly the window this fault covers and it is the most useful thing you can report.

Ask for the throttle body to be inspected and cleaned. Carbon build-up restricts the small airflow a raised cold idle needs, and it is a common, inexpensive cause.

Ask whether the coolant temperature sensor has been checked. If it reads warm when the engine is cold, the whole warm-up strategy is never properly invoked — the engine is healthy and the module simply does not know it is cold.

It matters more than it feels. Most of a car's harmful emissions come out in the first minute, so this is an MOT and emissions issue even though the car drives normally once warm.

Was dieser Code bedeutet

The engine did not hold the raised idle speed the cold-start strategy asked for.

This code belongs to a family that only exists for the first minute of a journey, and understanding why makes all seven of them readable. A catalytic converter converts nothing until it reaches around 300°C. On a cold start it is at ambient — so most of a modern petrol car's entire trip emissions are produced in the thirty to sixty seconds before the catalyst lights off.

Manufacturers therefore run a dedicated warm-up strategy whose only purpose is to get exhaust heat into the catalyst as fast as possible: ignition timing is retarded heavily, which dumps energy out of the exhaust valve instead of into the crankshaft, and idle speed is raised to push more hot gas through the converter.

This code says the raised idle was not achieved or not held.

The causes are the ordinary idle-control ones, but they show here first because cold start is when the demand is highest:

  • A carbon-coated throttle body, which restricts the small airflow a raised idle needs.
  • An unmetered air leak, which the module cannot compensate for cleanly when cold.
  • A coolant temperature sensor reading warm, so the strategy is never fully invoked. The engine is fine; the module thinks it is already warm.

That last one is worth checking early, because it is cheap and it silently disables the whole family.

Wahrscheinliche Ursachen

Hier anfangen

Seltener

Symptome

Beteiligte Bauteile

Information, keine Handlungsanweisung

CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.

Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.

Erfahrungen der Community

Schreiben Sie den ersten Erfahrungsbericht dazu

Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.

Was einen Bericht lesenswert macht:

  • Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
  • Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
  • Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.

Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P050A.