P0B0D: Steuergerät des Motors der Getriebeölpumpe
Was zu tun ist
This is one of the few codes where the electronics really are the likely answer — but only after the pump's windings and supply have been measured and found good. Ask whether the module is separate from the pump on this model: often it is not, and the two quotes are the same part.
Was dieser Code bedeutet
The module that drives the auxiliary pump has reported an internal fault.
A three-phase motor cannot be run by a switch. It needs electronics that synthesise three alternating supplies and shift them in step with the rotor, which is why this small pump has a control module of its own rather than a relay. That module has an output stage, and output stages fail.
The corpus's standing advice is not to blame the module, and this is one of the places that advice is deliberately reversed. P0964 sets out the test: a module is genuinely at fault when its circuits are reporting faults and the motor's windings measure correctly. Here the reasoning is the same. If the pump's windings are in specification and its supply is sound, what is left is the thing driving them.
One practical note before that conclusion: on many designs the module is integrated with the pump and is not separately available, so "replace the module" and "replace the pump" turn out to be the same job. Ask which it is on this vehicle before comparing quotes.
Wahrscheinliche Ursachen
Hier anfangen
- Zusatzpumpe für Getriebeöl defekt · Fachwerkstatt
Seltener
- Korrodierter oder loser Stecker · einfach
- Wasser in den Stecker eingedrungen · einfach
- Zu niedrige Systemspannung · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P0B0D.