P20BC: AdBlue-Heizung A — Steuerstromkreis hoch
Was zu tun ist
Ask for the connector to be checked first — including that it is plugged in and that its terminals are not scorched. These heaters carry real current, so a failing connection burns rather than merely corroding, and the damage is usually visible.
Mention any recent work underneath the vehicle, since a heater harness left unplugged after exhaust or tank work produces this exactly.
Fix it before winter. Nothing happens in warm weather — the fault only shows itself when the fluid actually freezes, and by then the emissions system has begun counting down towards a restart lockout.
Ask which part of the system this heater serves, since the tank, the lines and the injector are all heated separately and the cost differs considerably.
Was dieser Code bedeutet
The first reductant heater's control circuit is sitting higher than commanded.
This is the electrical sibling of the performance code on the same heater, and the difference decides where to look. Performance says the heater was driven and did not heat. This says the drive circuit itself is wrong — the module is not getting the electrical response it expects.
High means a short to a supply voltage or an open circuit, indistinguishable from inside the module and separated in a minute at the connector.
On a heater circuit the open case is far more likely, and heater circuits fail in a characteristic place. They carry real current, so a marginal terminal heats, oxidises further, heats more, and eventually burns through. Inspect for discoloured or melted connector plastic rather than simply testing continuity — that browning is the visible history of a connection that has been failing for months.
The trivial cause deserves eliminating first, as always: a heater or its harness left unplugged after work on the tank, the exhaust or the underbody produces exactly this, and on a recently serviced vehicle it is a real possibility that costs nothing.
Where the wiring is sound, the element has failed open, which is an ordinary end-of-life failure for a resistive heater.
The consequence is seasonal: nothing in summer, and frozen fluid with an inducement countdown at the first hard frost.
Wahrscheinliche Ursachen
Hier anfangen
- Leitungsbruch in der Steuerleitung · mittel
- Korrodierter oder loser Stecker · einfach
- Heizung der AdBlue-Leitung defekt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P20BC.