P24B7: Widerstand der Heizung des Partikelsensors
Was zu tun ist
This one usually does mean the sensor itself, rather than wiring — the module has measured the heating element and found it out of specification. It is still worth asking for the connector to be checked first, since corrosion there adds resistance and looks the same from the module's point of view.
Expect other faults from the same sensor to be stored alongside, and expect them to clear together, because a heater that cannot burn the sensor clean makes everything else it reports unreliable.
The car will drive normally. Time the repair around your MOT, since the emissions self-checks will not complete while this is stored.
Was dieser Code bedeutet
The measured resistance of the particulate matter sensor's heater is outside its expected range.
This is a more precise code than the heater circuit high and low pair, and it usually points at the sensor itself. The module is not reporting that the wire is shorted or open — it has measured the heater's actual resistance and found it wrong, which is a property of the element rather than of the harness.
A heater element ages by degrading, and degradation shows as resistance drift. Thousands of cycles from ambient to red heat gradually change the element, and once resistance moves far enough the module can no longer predict the temperature the heater will reach from the current it draws.
Temperature prediction is the point. The sensor has to burn its accumulated soot off completely and repeatably, and an element whose resistance has drifted either underheats — leaving residue that corrupts the next measurement — or overheats and shortens its own life further.
Harness resistance can still be the cause, and it is worth eliminating because it is cheaper. A corroded terminal adds resistance in series with the element, and the module cannot tell the difference between resistance in the wire and resistance in the heater.
So check the connector, then accept the sensor. Where the connector is clean and tight, this code is one of the more reliable indications that the part has genuinely reached the end of its life.
Wahrscheinliche Ursachen
Hier anfangen
- Partikelsensor defekt · mittel
- Hoher Widerstand in der Sensorleitung · mittel
- Korrodierter oder loser Stecker · einfach
Seltener
- Hitzeschaden an Sensor oder Leitung · mittel
Selten
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24B7.