P24AF: Partikelsensor — Stromkreis, Bereich/Funktion
Was zu tun ist
Ask whether a heater fault is stored alongside this code. If it is, that is very likely the real problem — this sensor cleans itself with a built-in heater, and one that is not working properly makes the sensor read nonsense.
Mention if the car burns oil or has had a coolant leak. Either can foul this sensor, and replacing it without addressing that leads to the same fault again.
The car will drive normally, so this is not urgent in the sense of being unsafe — but it is an emissions monitor, so leave enough time before an MOT for it to be fixed and for the car to complete its self-checks.
Was dieser Code bedeutet
The particulate matter sensor is producing a signal that is electrically valid but does not make sense.
Range/performance is the hardest of this family to diagnose and the most likely to be a genuine sensor failure. There is no open circuit and no short — the sensor is reporting a number, and the number is not credible.
The classic pattern is a sensor that never accumulates. It should slowly collect soot between regenerations, so its reading should drift in a predictable direction and then reset when the heater fires. A signal that sits flat forever, or one that jumps in a way soot accumulation physically cannot, is what sets this code.
Two mechanical explanations are worth ruling out before the sensor is condemned.
- The tip may be fouled with something other than soot. Oil or coolant reaching the exhaust coats the electrodes and stops them behaving predictably.
- The sensor may be in the wrong gas. After exhaust work, a sensor that sits in a pocket rather than the main stream sees very little of what is actually flowing.
A sensor whose self-regeneration heater is weak also lands here, because it never fully cleans itself and its baseline creeps. Check for a heater code alongside — if one is present, fix that first, because this code is then a consequence rather than a fault.
Wahrscheinliche Ursachen
Hier anfangen
- Partikelsensor defekt · mittel
- Sensor aus der Kalibrierung gedriftet · mittel
Seltener
- Öl- oder Kühlmittelverschmutzung an der Sensorspitze · Fachwerkstatt
- Sensor nach der Reparatur falsch positioniert · einfach
- Abgasleck stromaufwärts der Sonde · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24AF.