P2595: Turboladerdrehzahlsensor B — Stromkreis niedrig
Was zu tun ist
The engine will feel down on power. That is the module protecting the turbocharger because it cannot tell how fast it is spinning, so driving gently to a workshop is fine.
Ask for the wiring to be inspected before the sensor is replaced — this loom runs against a housing carrying exhaust gas and is among the hottest on the vehicle.
And mention it if the other turbocharger's speed sensor has set a code as well. Two at once usually means a shared power or earth wire rather than two failed sensors, and that is a far cheaper fix than replacing both.
Was dieser Code bedeutet
The second turbocharger's speed circuit reads below its valid range — a short to ground, a failed reference supply, or a sensor producing nothing where a signal is expected.
As at P2580, a reported zero is only impossible in context: a turbocharger genuinely is stationary with the engine off, so the module judges the reading against what the engine is doing and sets this code when a zero cannot be true. On a sequential system that context is narrower, because the second turbocharger legitimately turns slowly until the changeover brings it in — so the module has fewer conditions in which a zero is provably wrong, and the code often appears only after sustained higher-speed driving.
One check is worth doing before the sensor is condemned: read the A-side codes too. Both speed sensors are commonly fed from a shared reference supply and a common ground, and a failure there takes both down at once. Two speed codes together point at the supply rather than at two sensors, which is a much smaller repair than it first appears.
Without a usable signal the module caps boost protectively, so the engine feels flat.
Wahrscheinliche Ursachen
Hier anfangen
- Leitung mit Masse kurzgeschlossen · mittel
- Hitzeschaden an Sensor oder Leitung · mittel
- Drehzahlsensor des Turboladers defekt · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2595.