P2607: Ansaugluftheizung B — Stromkreis niedrig
Was zu tun ist
Expect poorer cold starting and more white smoke. Not damaging in itself, so getting to a workshop is fine.
One safety point worth passing on: if a fuse or fusible link for this circuit has blown, it must not be replaced with a bigger one. This heater draws a current comparable to a starter motor, and that fuse protects a heavy cable running across a hot engine. A blown one means something is shorting, and finding what is the repair — a larger fuse just removes the protection.
Was dieser Code bedeutet
The second intake air heater's control circuit reads below its valid range — normally a short to ground, or a driver output in the module that has failed low.
A short to ground on this circuit is worth taking seriously in a way that most low-circuit codes are not, because of what the circuit is connected to. The control side switches a relay, and the relay switches something drawing tens of amperes. A short on the control wire is an ordinary repair; a short on the supply side of the relay is a heavy cable trying to earth itself, which is a fire risk rather than an inconvenience. The fuse or fusible link protecting that cable is there for exactly this reason, and one that has blown should never simply be replaced with a larger one.
The cabling runs across the top of a hot engine to reach the manifold, so chafing against a bracket or a heat shield is the usual mechanism.
The driveability consequence is the same as the rest of the family: colder starting, more smoke, rougher running until warm.
Wahrscheinliche Ursachen
Hier anfangen
- Leitung mit Masse kurzgeschlossen · mittel
- Kabelbaum beschädigt · mittel
- Relais der Ansaugluftvorwärmung ausgefallen · mittel
Seltener
- Endstufe des Steuergeräts defekt · Fachwerkstatt
- Sicherung des Heizkreises durchgebrannt · einfach
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2607.