P2608: Ansaugluftheizung B — Stromkreis hoch
Was zu tun ist
Cold starting will be poorer and there will be more white smoke on a cold morning. Nothing here threatens the engine.
Ask for the heavy stud terminal on the heater itself to be checked and retightened before anything is bought. It sits on the inlet manifold, heats and cools thousands of times, and works loose — and because it looks like part of the manifold rather than part of the wiring, it is the connection people walk past.
If any work has recently been done on or around the inlet manifold, say so. That cable has to be moved to reach several things, and one left off or not properly tightened produces exactly this.
Was dieser Code bedeutet
The second intake air heater's control circuit reads above its valid range — an open circuit, a disconnected connector, or a short to supply.
An open circuit is the usual finding, and on this family it has a characteristic location: the heavy stud terminal on the heater itself. It sits on the intake manifold, is exposed to heat cycling and engine bay moisture, and is normally secured by a nut that relaxes slightly over years of expansion and contraction. A terminal that has worked loose arcs, corrodes and eventually opens — and it is the one connection on this circuit that nobody thinks to check because it looks like part of the manifold rather than part of a wiring loom.
A code appearing after work on the inlet manifold, the fuel filter or anything else that required that cable to be moved is a loose or unrefitted stud until proven otherwise, and retorquing it is the entire repair.
The consequence is the same as the rest of the family: worse cold starting, more smoke, rougher running until warm.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · einfach
- Leitungsbruch in der Heizungsleitung · mittel
- Heizelement der Ansaugluftvorwärmung ausgefallen · mittel
Seltener
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P2608.