Zum Inhalt springen

U0335 Hoch Generisch / SAE

U0335: Softwareinkompatibilität mit dem Sensormodul des Batteriepakets

WhatsApp Telegram X E-Mail

Was zu tun ist

Do not work around this, do not have it cleared, and do not attempt anything yourself. The high-voltage system runs at several hundred volts. Expect the car to refuse to charge, refuse to deliver power, or both.

That is protection, and it is worth understanding why the car is so firm about it.

This module is the one that measures your battery — every cell's voltage, the temperatures, the current flowing. But what those measurements mean depends entirely on its software: how many cells there are, how they are grouped, which reading belongs to which physical position.

When that description does not match the pack, the car does not get obvious nonsense. It gets steady, believable numbers about a battery it is not really looking at — a cell close to its limit reported against the wrong position, or a temperature read through the wrong curve.

The entire safety case for a lithium battery rests on knowing the condition of its worst cell. With that gone, refusing to work is the only honest answer.

One thing to insist on absolutely: no second-hand module. Battery packs are revised through a car's production life — different cells, different arrangement, often under the same part number — so a used one measures your pack through the wrong description of it. A matching part number is not enough, and this is a safety matter rather than a money one.

If part of the battery has been replaced, mention it — that is the commonest cause, and the job is not finished until every computer in the pack is on the same software.

Was dieser Code bedeutet

A module is running software that does not belong with the battery pack sensor module's. See U0300 for the family and U0312 for why this corner of the corpus is stricter than the rest — and note that this concerns a high-voltage system, with nothing on it for a general workshop to open.

The distinction from U0312 is worth drawing because the two are easily confused. The battery energy control module decides what the pack may do. This module measures what it is doing — individual cell voltages, module temperatures, pack current — and reports upward.

And its software is what makes those measurements mean anything. How many cells are in series, how they are grouped, which physical position each measured channel corresponds to, what the temperature sensors' response curves are, and how raw readings map to voltages.

So a mismatch here produces measurements that are consistent, stable and describing the wrong thing — and the danger is precisely that they are believable. A cell nearing its limit reported against the wrong position, or a temperature read through the wrong curve, gives a management system confident numbers about a battery it is not actually looking at.

Which is why the vehicle stops rather than derating. The whole safety case for a lithium pack rests on knowing the condition of the worst cell, and a measurement chain that cannot be verified removes that entirely. Refusing to charge or to deliver power is the correct answer.

The U0312 warning applies here with the same force and for the same reason: no second-hand module. Packs are revised through a model's life — different cells, different grouping, different sensors, frequently under one part numberand a sensor module from a donor pack measures this one through the wrong description of it. A matching part number is not enough, and this is one of the two places in the corpus where that shortcut has physical rather than financial consequences.

A pack section replaced after a fault is the commonest route in, and the job is not complete until every module on the pack is at one calibration.

Wahrscheinliche Ursachen

Hier anfangen

Seltener

Symptome

Beteiligte Bauteile

Information, keine Handlungsanweisung

CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.

Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.

Erfahrungen der Community

Schreiben Sie den ersten Erfahrungsbericht dazu

Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.

Was einen Bericht lesenswert macht:

  • Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
  • Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
  • Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.

Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu U0335.