P245B: Dérivation du refroidisseur de recirculation des gaz d'échappement — circuit de commande, plage/performance, banc 1
Que faire
This is worth attending to but rarely urgent. The car may run slightly rougher when cold or take longer to warm up, and the emissions system will not be working as intended.
Mention how the car behaves in the first few minutes from cold, since that is when the bypass does most of its work and when a fault here shows itself.
Ask whether the valve can be cleaned rather than replaced. Carbon build-up is the usual cause, these parts are expensive, and a valve that frees up and holds position afterwards has been genuinely repaired.
Short journeys make this worse. If most of your driving is a few miles at a time, an occasional longer run helps keep the whole exhaust gas recirculation system from coking up.
Ce que signifie ce code
The valve that routes exhaust gas around the EGR cooler is not moving the way the module commanded.
The bypass exists because recirculated exhaust gas is not always wanted cold. On a warm engine it is cooled before being fed back in, which lowers combustion temperature and suppresses the formation of nitrogen oxides. On a cold engine the opposite is useful — hot gas routed straight past the cooler helps the engine and the catalyst reach operating temperature faster.
Range/performance means the valve responded, but not correctly. It moved too slowly, stopped short of the commanded position, or the temperature downstream did not change in the way a working bypass would have produced. This is distinct from an open or shorted circuit, which sets a different code and is usually easier to find.
Carbon is the reason, most of the time. This valve sits directly in the exhaust stream, and soot builds up on the flap and its spindle until the mechanism binds. A valve that is merely sticky sets this code intermittently and cleanly for a while afterwards if it is freed, which is worth knowing before a new one is fitted.
Note that the fault may be thermal rather than mechanical. The module often infers bypass position from the coolant or gas temperature it expects to see, so a faulty temperature sensor produces this code with a perfectly good valve.
Causes probables
Commencez ici
Moins fréquent
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P245B.