P040F: Corrélation entre les capteurs A et B de température de recirculation des gaz d'échappement
Que faire
Leaving the car overnight genuinely helps here. This fault is diagnosed from stone cold, when both sensors should read the same as the outside air — a warm engine tells the garage much less.
Ask whether the EGR cooler has been checked, not just the sensors. These two sensors sit either side of the cooler and measure whether it is working, so a blocked or bypassed cooler produces this code with two perfectly good sensors.
Mention any white smoke from the exhaust or coolant disappearing without a visible leak. An EGR cooler can split internally and leak coolant into the engine, which is a far more serious finding and worth flagging early.
Frequent short journeys accelerate soot build-up in the whole EGR system, so occasional longer runs help.
Ce que signifie ce code
The two EGR temperature sensors disagree by more than the module allows.
Two sensors on an EGR path are usually placed either side of the cooler, and that arrangement is the whole point of this code. The difference between them is the cooler's effectiveness, measured directly — hot gas in, cooled gas out. The module does not need to guess whether the cooler is working; it can watch it happen.
So a correlation fault means one of two quite different things.
- One sensor has drifted or is soot-fouled, so the measured difference is wrong while the cooler is fine.
- The difference genuinely is not there — the cooler is blocked, bypassed, or its coolant flow has stopped, so gas leaves at nearly the temperature it entered.
The cold soak separates them without a road test. After the vehicle has stood overnight both sensors must read close to ambient and close to each other. If they disagree then, a sensor is at fault; if they agree cold and fail to diverge when running, the cooler is.
That single check answers the question the code cannot, and it costs nothing but leaving the car overnight.
A cooler that is not cooling is worth finding for a second reason. An internally split EGR cooler leaks coolant into the intake, which shows as white exhaust smoke and coolant disappearing with no visible leak — a much larger problem than a sensor.
Causes probables
Commencez ici
- Refroidisseur EGR encrassé de suie · modérée
- Encrassement par la suie dans l'orifice du capteur · modérée
- Capteur de température EGR défectueux · modérée
Moins fréquent
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P040F.