P20EE: Eficiência do catalisador SCR de NOx abaixo do limiar — banco 1, catalisador 1
O que fazer
Do not agree to a catalyst replacement on this code alone. It says the emissions system is not converting enough, which has several possible causes — and the catalyst is usually not the first one. Faulty sensors, poor quality fluid, or a blocked injector all produce this and cost a fraction as much.
Ask what else is stored. If there is a fault about reductant dosing, quality or pressure, that is very likely the actual problem.
Mention where the reductant fluid has come from. Weak or wrong fluid is a common cause, and months of it is also what wears a catalyst out early.
Do not leave it. The system escalates towards limiting the vehicle's speed and eventually refusing to restart — and fixing it at that stage is far more disruptive.
O que este código significa
The selective catalytic reduction catalyst is not converting enough nitrogen oxide.
This is the headline code of the whole SCR system — the outcome measurement that everything else in this block exists to make possible. The module compares NOx before and after the catalyst and concludes the conversion rate is too low.
Which makes it the least specific code in the family and the one most often misread. It names the result, not the cause, and the catalyst itself is only one of several explanations — often not the likeliest.
Work outward from the cheapest.
- The NOx sensors. They are the measurement, so a lazy or drifted downstream sensor reports poor conversion that is not happening. Verify them before condemning a catalyst.
- Dosing. Fluid quality, a blocked or crystallised injector, low pressure, an empty tank. If reductant is not arriving, no catalyst can convert anything — and every one of those has its own code in this block.
- Exhaust leaks between the sensors, which admit air and skew the reading.
- The catalyst itself, aged, thermally damaged, oil-poisoned or sulphur-poisoned — and this is where a catalyst that has been fed weak fluid for months ends up.
Read every stored code before deciding. A dosing fault alongside this one is almost certainly the cause, and replacing the catalyst without fixing it destroys the replacement too.
Expect escalation. A system that cannot meet its target moves through the inducement stages towards a restart lockout.
Causas prováveis
Comece aqui
- Sensor de NOx com defeito · moderado
- Arla 32 diluído ou fluido incorreto · moderado
- Injetor de Arla 32 cristalizado · moderado
Menos comum
- Catalisador SCR envelhecido ou contaminado · especializado
- Vazamento de escape a montante do sensor · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P20EE.