P2423: Catalisador de adsorção de hidrocarbonetos — eficiência abaixo do limiar, banco 1
O que fazer
The car will drive normally — this device only does anything in the first minute after a cold start, so there is nothing to feel. It will fail an emissions test. Before agreeing to replace it, ask whether the oxygen sensors have been verified, because the efficiency judgement is calculated from them and a drifting sensor condemns a healthy exhaust component. This is not a repair to rush into on the strength of one code.
O que este código significa
The hydrocarbon adsorption catalyst on bank 1 is not storing and releasing as it should.
This device solves the same problem as secondary air injection, by the opposite method. The problem is that the first minute after a cold start produces the worst emissions a car makes, because the catalyst converts almost nothing until it is hot. Secondary air injection attacks it by burning the unburnt fuel early, generating heat — that is P2257. An adsorption catalyst instead simply traps the hydrocarbons on a zeolite substrate, holds them while the exhaust is cold, and releases them back into the stream once the main catalyst is up to temperature and able to deal with them.
So it is a delay line rather than a converter, and that shapes what failure looks like. It does not stop working suddenly. The substrate loses storage capacity gradually with age, thermal cycling and contamination, so the code appears when capacity has fallen below what the strategy assumes rather than when something breaks. There is usually no symptom at all — the driver notices nothing, and the fault is found at an emissions test or by the warning light.
Before concluding the trap itself is finished, the same caution applies as for any catalyst efficiency code: the judgement is made using oxygen sensors, so a sensor reporting inaccurately produces this verdict on a healthy device. The corpus makes that argument at P2270 and P2232, and it is worth the same weight here, because this is an expensive exhaust component.
Causas prováveis
Comece aqui
- Colmeia do adsorvedor de hidrocarbonetos degradada · especializado
- Sensor de oxigênio defeituoso · moderado
Menos comum
- Vazamento no escapamento antes do sensor · moderado
- Consumo excessivo de óleo ou líquido de arrefecimento · especializado
- Partidas a frio repetidas em trajetos muito curtos · fácil
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P2423.