P244A: Pressão diferencial do filtro de partículas — muito baixa, banco 1
O que fazer
The car will very likely feel completely normal, and that is the point of getting it looked at. This code says the filter may not be filtering — which is an MOT and emissions problem rather than something you will notice from the driver's seat.
The usual cause is a pair of small pressure hoses, which is a cheap repair, so do not assume the worst before it has been inspected.
If this vehicle has been bought recently, mention that. A hollowed-out filter is a known way of disguising a failed one before a sale, and it produces exactly this reading. A garage can tell the difference by looking; you cannot.
O que este código significa
The pressure difference across the particulate filter is lower than a working filter should ever produce.
A filter is a restriction, and that is the point of it. Gas entering it is at a measurably higher pressure than gas leaving it, and the module watches that difference to judge how full the filter is. A difference of almost nothing means the gas is not being filtered.
There are three explanations and they are very different in cost.
- The sensor or its pipework is at fault — the two small hoses that carry pressure from the exhaust to the sensor block with soot, split, or get swapped. This is the commonest cause and the cheapest.
- There is a leak between the two measuring points, so both hoses see much the same pressure regardless of the filter.
- The filter substrate has failed or been removed. A cracked or melted core, or a shell that has been hollowed out, passes gas freely — and reads exactly like this.
That last case is why this code matters more than its symptoms suggest. The car will usually drive perfectly, and a filter that is not filtering is emitting everything it was fitted to catch.
Check the hoses before anything else, including that they are on the right ports: reversed hoses produce a reading that is wrong in a way no amount of sensor replacement fixes.
Causas prováveis
Comece aqui
Menos comum
- Mangueiras do sensor de pressão invertidas · fácil
- Colmeia do filtro de partículas trincada ou inoperante · especializado
- Vazamento de escape a montante do sensor · moderado
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P244A.