P0919: Fehler der Schaltpositionsregelung
Was zu tun ist
Ask for two things before a gearbox is opened: that the clutch is confirmed to be releasing fully, and that the actuator calibration is re-run. A dragging clutch makes every gear hard to engage and is a smaller repair than a synchroniser. If both check out, this code is most likely telling you the gearbox is wearing rather than that a part has failed.
Was dieser Code bedeutet
The shift mechanism did not reach the position it was commanded to. Circuits check out and the sensor is credible; the movement itself failed to complete.
This is the automated manual's clutch-wear code, and it is worth reading as one. Engaging a gear on a synchronised gearbox means bringing two shafts to the same speed through the synchroniser ring, then sliding the collar across. A worn synchroniser takes longer to match those speeds. A human driver never notices, because a hand naturally holds pressure until the gear goes in. A robot works to a fixed force and a timeout — so a synchroniser that has worn past a certain point produces a shift that simply does not complete in the time allowed, and the module records it.
That makes P0919 a measurement of gearbox wear expressed as an electronic fault, which is exactly the shape of P0810 for the clutch. Both are adaptive systems reporting that they have run out of adaptation, and both are far more often wear reports than component failures.
A clutch that is not fully releasing produces the same code by a different route: with drag still on the input shaft, the synchroniser is fighting the engine as well as the shaft inertia. That is worth eliminating first, because it is the cheaper of the two.
Wahrscheinliche Ursachen
Hier anfangen
- Synchronring verschlissen · Fachwerkstatt
- Kupplung trennt nicht vollständig · Fachwerkstatt
- Kalibrierung des Getriebestellers verloren · mittel
Seltener
- Schaltsteller defekt · Fachwerkstatt
- Zu niedriger Hydraulikdruck im Stellersystem · Fachwerkstatt
- Schaltgestänge verschlissen · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P0919.