P0EFC: Eingangsspannungssensor C des Batterieladegeräts A — Stromkreis, Bereich/Funktion
Was zu tun ist
The car will drive. Charging may be much slower at three-phase charge points while remaining normal at home, which is the signature of this fault rather than of a tired battery or a bad charger. Note where it is slow and by how much.
Was dieser Code bedeutet
The circuit for one of the charger's input voltage sensors is faulty.
Three sensors watching the charger's alternating-current input is not redundancy — it is almost certainly three phases.
A domestic supply has one live conductor. A three-phase supply has three, and much of the world's public and commercial charging is three-phase, because it delivers three times the power through conductors of the same size. A charger able to use it must measure each phase separately.
Which gives these codes an unusually specific diagnostic value: they name a phase. A fault on sensor B alone points at one leg of the supply — one conductor of the cable, one pin in the inlet, one branch of the installation — and that is a far smaller thing to inspect than "the charging system".
It also explains a complaint that otherwise makes no sense: a car that charges at full speed from one three-phase point and at a third of the rate from another. A charger that cannot verify one phase will not use it, so it falls back to single-phase charging and the driver sees a rate that has inexplicably collapsed at some chargers and not others.
So the test is not "does it charge" but "how fast, and where". A clean fall to a third of the expected rate on a three-phase point is close to diagnostic.
Reads plausibly and disagrees with the other phases. On a three-phase supply the other two are the reference — they should be equal in magnitude, so one differing is caught immediately.
Wahrscheinliche Ursachen
Hier anfangen
- Onboard-Ladegerät defekt · Fachwerkstatt
- Korrodierter oder loser Stecker · Fachwerkstatt
Seltener
- Ladebuchse oder Kontakte beschädigt · mittel
- Leitungsbruch in der Sensorleitung · Fachwerkstatt
- Kabelbaum beschädigt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P0EFC.