P21C4: Relais der AdBlue-Heizung — Steuerstromkreis hoch
Was zu tun ist
This is one of the cheaper faults in the reductant system, so it is worth fixing promptly rather than waiting — a relay or its socket is inexpensive, and everything that heats the reductant stops working when it fails.
Ask for the relay socket to be inspected as well as the relay. These carry heavy current, and the socket terminals heat and spread over years — a new relay pushed into a burnt socket fails again.
Get it done before deep winter. In mild weather nothing happens at all; the first hard frost freezes the fluid and starts the countdown towards the vehicle refusing to restart.
Mention any recent work in the fuse or relay box, since a relay not fully seated produces this exactly.
Was dieser Code bedeutet
The control circuit for the reductant heater relay is reading higher than commanded.
A relay sits between the control module and the heaters for a straightforward reason: current. Heating a tank of reductant and several metres of line draws far more than a module output can switch directly, so the module drives a relay coil and the relay carries the load.
This code is about the coil circuit, not the load. The heaters may be perfect and the relay contacts fine — the module simply cannot drive, or cannot verify, the coil.
Reading high means a short to a supply voltage or an open circuit, and the module cannot distinguish them from inside. Measuring at the relay socket with the relay removed separates them in a minute.
The open case is the more likely, and relay sockets are where it happens. A relay that has been carrying heavy current for years heats its socket terminals, which spread and oxidise until the coil circuit no longer makes reliable contact. Look for discoloured plastic around the terminals rather than only testing continuity.
This is the cheapest fault in the reductant heating family and the one most worth catching early, because everything downstream of it — tank heater, line heaters, the lot — stops working when the relay does.
The consequence is seasonal and silent: nothing in summer, frozen fluid and an inducement countdown at the first hard frost.
Wahrscheinliche Ursachen
Hier anfangen
- Leitungsbruch in der Ansteuerleitung des Relais · mittel
- Korrodierter oder loser Stecker · einfach
- Relais der AdBlue-Heizung ausgefallen · einfach
Seltener
- Hitzeschaden an der Leitungsisolierung · mittel
- Leitung mit Spannung kurzgeschlossen · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P21C4.