P24B1: Partikelsensor — Stromkreis hoch
Was zu tun ist
Ask for the connector under the car to be checked first, including that it is actually plugged in. A sensor left unplugged after exhaust or filter work sets exactly this code, and that is worth ruling out before anything is bought.
Mention any recent work underneath the vehicle, since a disturbed or unlatched connector is one of the commonest causes here.
The car will drive normally. The concern is the emissions monitor rather than driveability, so plan the repair around your MOT date rather than treating it as an emergency.
Was dieser Code bedeutet
The particulate matter sensor signal is above the highest voltage the circuit should ever produce.
A signal pinned high has two quite different explanations, and separating them is the whole job. Either the wire has shorted to a supply voltage, or the circuit is open and the module is seeing its own pull-up with nothing loading it.
Both look identical from inside the module, which is why this code cannot be diagnosed from the scan tool alone. Unplugging the sensor and measuring at the connector separates them in a couple of minutes — an open circuit and a short to power behave completely differently once the sensor is out of the loop.
Because the sensor sits under the vehicle, the mechanical causes are the usual ones for that location: a harness pulled apart by stone damage, a connector unlatched by a previous repair, or a terminal that has corroded until it no longer makes contact.
Do not overlook the trivial case. A sensor left unplugged after exhaust work sets exactly this code, and it is a genuinely frequent finding on a car that has just been in for something else.
A sensor whose element has failed open also lands here, so the part is a real possibility — just not the first one to check.
Wahrscheinliche Ursachen
Hier anfangen
- Leitungsbruch in der Sensorleitung · mittel
- Sensor nach früheren Arbeiten nicht wieder angeschlossen · einfach
- Korrodierter oder loser Stecker · einfach
Seltener
- Leitung mit Spannung kurzgeschlossen · mittel
- Partikelsensor defekt · mittel
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24B1.