P24AE: Partikelsensor — Stromkreis
Was zu tun ist
The car will almost certainly drive normally, and this still needs attention. This sensor is the one that checks the particulate filter is doing its job, so with it faulty the car cannot prove its emissions system works — which is an MOT problem before it is a driving one.
Ask for the connector and wiring under the car to be inspected first. The sensor lives in the exhaust stream where road salt and water reach it, and corrosion there is a common cause and a cheap fix.
Mention any recent work under the vehicle — exhaust repairs, a filter change, or anything that involved unplugging things underneath — since a disturbed connector is a frequent cause.
Was dieser Code bedeutet
A general electrical fault has been detected in the particulate matter sensor circuit.
This sensor is easily confused with the pressure sensors on the same filter, and it does something completely different. A differential pressure sensor infers how full the filter is from how much it restricts the flow. A particulate matter sensor measures soot in the gas directly, after the filter, and its job is to catch a filter that has failed — cracked, melted, or removed — and is letting particulates straight through.
It works by collecting soot on an electrode pair and measuring the current that starts to flow once enough conductive carbon bridges the gap. Then it burns itself clean with an internal heater and starts again, so its normal operating cycle is accumulate, measure, regenerate, repeat.
That construction explains the failure modes. It carries a signal circuit, a heater circuit and a supply, and this code covers a general fault on the sensor circuit without narrowing which.
This is the family's front door and the least specific member of it. Where a low, high, intermittent or heater code is stored alongside, that one is the useful diagnosis.
Check the connector before the sensor. It sits under the vehicle in the exhaust stream, exposed to road salt and water, and corroded pins are a more common finding here than a failed element.
Wahrscheinliche Ursachen
Hier anfangen
- Korrodierter oder loser Stecker · einfach
- Partikelsensor defekt · mittel
Seltener
- Kabelbaum beschädigt · mittel
- Wasser in den Stecker eingedrungen · einfach
- Sensor nach früheren Arbeiten nicht wieder angeschlossen · einfach
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P24AE.