P278C: Kick-down-Schalter — Stromkreis niedrig
Was zu tun ist
Drive normally — but do not plan an overtake around the kick down until it is repaired. Flooring the pedal may not deliver the immediate downshift you expect, so allow more room than usual. If you need stronger acceleration in the meantime, select a lower gear manually before committing rather than relying on the pedal.
Was dieser Code bedeutet
The kick down switch circuit is reading low.
A constant low usually means the line is shorted to ground — the module sees the switch held permanently in one state, so it stops trusting anything the circuit says.
Kick down is the floor-it request. Push the accelerator through the last of its travel and the transmission drops a gear or two at once for maximum acceleration — the overtaking reflex. On older automatics the request comes from a physical switch under the pedal's full travel; on newer cars it is a firm detent at the end of the pedal sensor's range that behaves as one. This circuit is that switch.
The car drives normally without it. Gears still change on schedule and the throttle still works. What is lost is the emergency reflex: flooring the pedal produces strong acceleration in the current gear rather than the immediate downshift you were counting on. The difference only shows at the moment you need it most, which is what makes an unrepaired kick down circuit worth more respect than its symptoms suggest.
Check the simple things before the expensive ones. A floor mat riding up under the pedal, a switch knocked out of adjustment, a connector disturbed by footwell work — the kick down switch lives in one of the harshest, most trodden corners of the car, and it corrodes and shifts like anything else that lives there.
Wahrscheinliche Ursachen
Hier anfangen
- Kickdown-Schalter defekt · mittel
- Korrodierter oder loser Stecker · Fachwerkstatt
Seltener
- Kabelbaum beschädigt · Fachwerkstatt
Selten
- Getriebesteuergerät defekt · Fachwerkstatt
Symptome
Beteiligte Bauteile
Information, keine Handlungsanweisung
CarGeek ist ein Nachschlagewerk, kein Werkstatthandbuch. Die Seiten entstehen aus öffentlichen Quellen und aus dem, was andere festgestellt haben, nie aus den Serviceunterlagen des Herstellers; für Ihr konkretes Fahrzeug können sie daher falsch oder unvollständig sein. Ein Teil des Beschriebenen birgt echte Gefahren: Hochspannung, Kraftstoff unter Druck, gespeicherte Energie sowie heiße oder bewegte Teile.
Lassen Sie alles, wonach Sie handeln wollen, von einer fachlich geschulten Person anhand der herstellereigenen Vorgehensweise für Ihr Fahrzeug prüfen. Nichts hiervon ersetzt diese Vorgehensweise.
Erfahrungen der Community
Schreiben Sie den ersten Erfahrungsbericht dazu
Dazu wurde noch nichts veröffentlicht. Was immer Sie gefunden haben, ist es wert, aufgeschrieben zu werden — selbst eine Sackgasse erspart jemandem denselben Nachmittag.
Was einen Bericht lesenswert macht:
- Das Fahrzeug — Marke, Modell, Baujahr und Motor. Derselbe Fehler verhält sich auf jedem anders.
- Was Sie gemessen haben, nicht nur, was Sie getauscht haben.
- Was es tatsächlich behoben hat — oder dass nichts es behoben hat, was ebenso nützlich ist.
Anmelden oder ein Konto anlegen und eintragen, was Sie gefunden haben — zu P278C.