P008A: Circuit carburant basse pression — pression trop basse
Que faire
Ask when the fuel filter was last changed. A restricted filter is the commonest cause of this and by far the cheapest to put right — worth eliminating before anything larger is considered.
Do not put off the repair. On a direct injection engine the fuel lubricates the high-pressure pump, and running it short of feed pressure wears that pump out — so a fault that starts as a filter can end as a pump plus a system flush.
Ask for the voltage at the fuel pump to be measured under load, not just its resistance. A corroded connector slows a perfectly good pump, and that is a much smaller repair than dropping the fuel tank.
Try to keep more than a quarter of a tank. Fuel around the pump helps cool it, and a struggling pump run near empty fails sooner.
Ce que signifie ce code
The low-pressure side of the fuel system is below the pressure it should hold.
A direct injection engine has two fuel systems, and separating them is the whole point of this code. The low-pressure side runs from the tank pump to the high-pressure pump at a few bar. The high-pressure side runs from there to the injectors at a hundred bar or more. This code names the first of those.
Which matters because low feed pressure damages the high-pressure pump. These pumps are lubricated by the fuel passing through them, and a starved pump cavitates rather than compresses — so it wears rapidly and its debris then circulates through the whole system. A cheap fault left alone becomes an expensive one.
The causes are ordinary and ordered by cost.
- A restricted fuel filter, which is the commonest and cheapest. Worth eliminating first on any vehicle with an unknown filter history.
- A weak or worn tank pump, or a blocked strainer on its inlet.
- A leak or air ingress on the suction side, which is compressible and defeats a pump entirely.
- A wiring fault starving the pump of voltage, which reads as a weak pump and is not.
Measure the voltage at the pump under load before condemning it. A corroded connector drops enough voltage to slow a healthy pump, and that is a far cheaper repair than dropping a tank.
Expect hard starting, hesitation under load, and cutting out as the fault worsens.
Causes probables
Commencez ici
- Filtre à carburant colmaté · facile
- Pompe à carburant faible · modérée
Moins fréquent
- Crépine de pompe à carburant obstruée · modérée
- Air aspiré dans l'alimentation en carburant · modérée
- Tension basse à la pompe à carburant · modérée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P008A.