P2205: Chauffage du capteur de NOx — circuit de commande ouvert, banc 1 capteur 1
Que faire
The car drives normally and the inducement countdown described under P2200 still applies. Worth knowing for the future: these sensors are hardest hit by short journeys, because the exhaust never dries out and the heater has to work around condensation on every start. Where the vehicle's use allows it, a longer run occasionally is genuinely kinder to the emissions system than a series of short ones — the same is true of the particulate filter.
Ce que signifie ce code
A fault in the circuit driving the NOx sensor's heater. The heater is not an accessory on this sensor — without it there is no measurement at all, so a heater fault and a sensor fault have the same practical result.
Why the element has to be hot. The measurement depends on oxygen ions moving through a ceramic electrolyte, and that ceramic only conducts them at high temperature — several hundred degrees, well above what exhaust gas alone reliably provides at low load or in traffic. So the sensor carries a heater whose job is to hold the element at its working temperature regardless of what the exhaust is doing. Cold, the sensor is not inaccurate; it is blind.
And why the heater is deliberately delayed after a cold start — which explains a real ownership pattern. A cold exhaust is full of condensation. Combustion produces water, and until the pipe is warm that water sits in it as liquid. A droplet reaching a ceramic element already heated to working temperature causes it to crack from thermal shock, instantly and permanently. So the module holds the heater off, or ramps it very gently, until it calculates the exhaust is dry.
The consequence is that short journeys are unusually hard on these sensors. A vehicle that never runs long enough to dry its exhaust spends its life in the condensation phase, accumulating water in the system and giving the heater strategy a difficult problem on every start. It is one of the more concrete reasons why the same sensor lasts markedly longer on one car than another, and it is worth knowing rather than treating the failure as bad luck.
A heater circuit fault, then, disables the sensor and starts the inducement sequence described at P2200 — with the car driving perfectly throughout.
Causes probables
Commencez ici
- Capteur de NOx défectueux · modérée
- Circuit ouvert dans le câblage du réchauffeur · modérée
- Connecteur corrodé ou mal enclenché · facile
Moins fréquent
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P2205.