P245F: Capteur B de pression du filtre à particules — circuit, plage/performance
Que faire
Ask for the sensor's pressure pipes to be checked and cleared before the sensor is replaced. They block with soot, that is the commonest cause of this code, and clearing them costs almost nothing next to a new sensor.
Mention whether the car has been running regenerations more often than usual — a cooling fan running on after parking, or a hot smell — since that is the symptom this fault produces before anything else becomes obvious.
Do not leave it indefinitely. While this sensor is misreading, the system cannot tell how full the particulate filter is, and the failure that follows is a blocked filter, which is a far larger bill.
Ce que signifie ce code
The second particulate filter pressure sensor is producing a reading that is electrically valid but not credible.
Some systems measure filter loading with two absolute pressure sensors rather than one differential sensor — one before the filter and one after — and compute the difference themselves. Sensor B is the second of that pair, and this code says its output does not agree with what the rest of the system implies it should be.
The signal is in range, which is what makes this harder than a circuit fault. There is no open, no short, and nothing obviously broken; the number is simply wrong. The classic evidence is a sensor that reads a plausible pressure with the engine stopped, when it should be reading atmospheric like everything else.
Soot in the sensor's take-off pipe is the usual cause. These pipes are narrow, they run hot, and they slowly fill — and a partially blocked pipe damps the reading rather than killing it, which is exactly how a sensor ends up plausible and wrong.
Blow the pipes through before condemning the sensor. It is a five-minute check that resolves a large share of these.
The consequence is that the module cannot judge filter loading correctly. It may command regenerations that are not needed, or fail to command one that is — and the second of those quietly blocks the filter.
Causes probables
Commencez ici
Moins fréquent
- Résistance élevée dans le câblage du capteur · modérée
- Fuite d'échappement en amont de la sonde · modérée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de P245F.