U0133: Perte de communication avec le calculateur de contrôle actif du roulis
Que faire
The car will lean more in corners than you are used to, and feel less settled at speed. It is safe to drive; just allow for it.
Your car has anti-roll bars it can stiffen and soften rather than fixed ones, and this code means the computer controlling them has stopped talking to the rest of the car. The system has defaulted to a fixed setting, so the car now handles like an ordinary one.
The reason this page exists is that the change gets blamed on the wrong thing. "The car has gone soft in corners" is normally investigated as worn shock absorbers, tired bushes or sagging springs — and those parts get replaced without fixing anything, because the suspension is fine. If this code is stored, say so before agreeing to any suspension work.
If your vehicle is one that disconnects its bars for off-road use, stop relying on that — it will lift a wheel earlier on uneven ground than you expect.
The usual causes are the wiring and connectors at the axles, which live in the road salt and flex with the suspension, or on hydraulic systems the pump's power supply.
Ce que signifie ce code
The active roll control module has stopped being heard from. The general reasoning is at U0100, and U0434 covers the same module reporting implausibly instead.
Active roll control replaces a fixed anti-roll bar with one the vehicle can stiffen, soften or disconnect — hydraulically on older systems, with 48-volt electric actuators on newer ones. It exists because the two things an anti-roll bar has to do are in conflict: stiff enough to keep a tall vehicle flat through a corner is too stiff to let a wheel drop into a rut, and a controllable bar can be both.
When the module goes quiet the system defaults to a fixed state, and the vehicle reverts to behaving like one with ordinary anti-roll bars.
The consequence is a handling change rather than a failure, and it is worth naming because of how it gets diagnosed. The vehicle leans noticeably more in corners than its driver is used to, and feels less settled on a motorway. That is normally investigated as worn dampers, tired anti-roll bar bushes or dropped springs — parts that get replaced without changing anything, because the suspension is fine and the system that was flattening it has switched off.
So a stored roll control code alongside a "the car has gone soft" complaint is the cheap explanation, and it should be eliminated before anything is unbolted.
On the off-road side the loss runs the other way. A vehicle that decouples its bars for articulation cannot do so, so it lifts wheels earlier on uneven ground. That is a capability to stop relying on rather than a hazard.
Where the fault is: actuators and their wiring live at the axles, in the spray and salt, on harnesses that move with the suspension through their whole travel. Hydraulic systems add a pump and a pressure sensor whose supply is a common single point of failure.
Causes probables
Commencez ici
- Connecteur corrodé ou mal enclenché · facile
- Faisceau de câblage endommagé · modérée
- Infiltration d'eau dans le connecteur du calculateur · modérée
- Fusible grillé ou alimentation hors service · facile
Moins fréquent
- Alimentation ou masse du calculateur hors service · modérée
- Câblage du bus de données endommagé · modérée
Symptômes
Composants concernés
Des informations, pas des instructions
CarGeek est un ouvrage de référence, pas un manuel d'atelier. Ses pages sont rédigées à partir de sources publiques et de ce que d'autres ont constaté, jamais à partir de la documentation technique du constructeur ; elles peuvent donc être erronées ou incomplètes pour votre véhicule précis. Une partie de ce qu'elles décrivent présente un risque réel : haute tension, carburant sous pression, énergie accumulée, pièces chaudes ou en mouvement.
Avant d'agir sur quoi que ce soit, faites-le vérifier par une personne formée, en suivant la procédure du constructeur pour votre véhicule. Rien ici ne remplace cette procédure.
Expérience de la communauté
Soyez le premier à en faire le compte rendu
Rien n'a encore été publié à ce sujet. Tout ce que vous avez trouvé mérite d'être noté — même une impasse épargne à quelqu'un le même après-midi.
Ce qui rend un compte rendu utile :
- La voiture — marque, modèle, année et moteur. La même panne ne se comporte pas pareil sur chacune.
- Ce que vous avez mesuré, pas seulement ce que vous avez remplacé.
- Ce qui a réellement résolu le problème — ou que rien ne l’a résolu, ce qui est utile aussi.
Se connecter ou créer un compte pour ajouter ce que vous avez trouvé à propos de U0133.