P0C2A: Bomba elétrica ou auxiliar A de óleo da transmissão — motor parado
O que fazer
If this appeared on a very cold morning and the car has been fine since, say so — thick fluid can stall this pump without anything being wrong with it, and that is a much better outcome than the alternative. Otherwise the likely causes are physical: debris or a seizing pump. Fluid condition is the cheap thing to check first, and a pump replaced into dirty fluid tends to stall again.
O que este código significa
The auxiliary pump has been commanded to turn and has not turned.
This is the least ambiguous code in the family and the most actionable. Everything else in it describes a measurement being wrong; this describes a mechanical fact. The module knows the pump is stalled because it is drawing current and producing no rotation — the electrical side is working and the shaft is not moving.
That narrows it to a short list of physical causes. Debris is first, because this pump is small, its clearances are tight, and it draws from the same fluid as everything else in the gearbox — so wear particles reach it. A seizing bearing is second. And fluid too cold and thick to move is a genuine third that is not a fault at all: some designs will report a stall on a hard frost and run perfectly once warm, which is worth knowing before a pump is bought on the strength of one winter morning.
A stalled pump means no line pressure with the engine off, so the P0B00 symptoms arrive in full.
Causas prováveis
Comece aqui
- Motor da bomba travado · especializado
- Detritos no fluido da transmissão · especializado
- Bomba auxiliar do fluido da transmissão com defeito · especializado
Menos comum
Sintomas
Componentes envolvidos
Informação, não instrução
O CarGeek é uma referência, não um manual de serviço. Suas páginas são escritas a partir de fontes públicas e do que outras pessoas constataram, nunca a partir da documentação de serviço do fabricante, de modo que podem estar erradas ou incompletas para o seu veículo específico. Parte do que descrevem envolve risco real: alta tensão, combustível sob pressão, energia acumulada e peças quentes ou em movimento.
Antes de agir com base em qualquer orientação, peça a verificação de uma pessoa com formação técnica, seguindo o procedimento do próprio fabricante para o seu veículo. Nada aqui substitui esse procedimento.
Experiência da comunidade
Seja o primeiro a documentar isto
Ainda não há publicações sobre isto. Vale a pena anotar tudo o que você descobriu — até um beco sem saída poupa a mesma tarde de outra pessoa.
O que faz valer a leitura:
- O carro — marca, modelo, ano e motor. A mesma falha se comporta de forma diferente em cada um.
- O que você mediu, não só o que trocou.
- O que realmente resolveu — ou que nada resolveu, o que também vale saber.
Entrar ou criar uma conta para adicionar o que você descobriu sobre P0C2A.